-
Из-за обновления GTA 5 (был добавлен новый патч) может временно не работать вход в RAGE Multiplayer.Ошибка: Ваша версия Grand Theft Auto V не поддерживается RAGE Multiplayer.ERROR: Your game version is not supported by RAGE Multiplayer.Данная ошибка говорит о том, что GTA V обновилась до новой версии (GTA Online тоже). Вам необходимо обновить саму игру в главном меню вашего приложения (Steam / Epic Games / Rockstar Games). Если после этого RAGE:MP все равно не работает - вам нужно дождаться выхода патча для самого мультиплеера (обычно это занимает от нескольких часов до нескольких дней). Новости и апдейты Rockstar Games - https://www.rockstargames.com/newswire/ Статус всех служб для Rockstar Games Launcher и поддерживаемых игр: https://support.rockstargames.com/ru/servicestatus
Grand Theft Auto 5 (+ GTA Online) последний раз были обновлены:
To change the spawn location in RedAge V3, you will typically need to access the server's configuration files. Here are the general steps:
1. Locate the server's configuration files. These are usually stored in a folder called "config" or "plugins" within the server's directory.
2. Look for a file named something like "redagev3.cfg" or "spawn.cfg." Open this file using a text editor.
3. Inside the configuration file, you should find a section specifying the spawn location. Look for parameters such as coordinates or spawnX, spawnY, spawnZ.
4. Adjust the coordinates or values according to your desired spawn location. Make sure to save the changes to the configuration file.
5. Restart the server for the changes to take effect. Players will now spawn at the new location specified in the configuration file.
Note: The exact steps may vary depending on the specific version of RedAge V3 you are using and the server setup. If you are unsure, it's recommended to consult the documentation or support forums for RedAge V3.
1. Locate the server's configuration files. These are usually stored in a folder called "config" or "plugins" within the server's directory.
2. Look for a file named something like "redagev3.cfg" or "spawn.cfg." Open this file using a text editor.
3. Inside the configuration file, you should find a section specifying the spawn location. Look for parameters such as coordinates or spawnX, spawnY, spawnZ.
4. Adjust the coordinates or values according to your desired spawn location. Make sure to save the changes to the configuration file.
5. Restart the server for the changes to take effect. Players will now spawn at the new location specified in the configuration file.
Note: The exact steps may vary depending on the specific version of RedAge V3 you are using and the server setup. If you are unsure, it's recommended to consult the documentation or support forums for RedAge V3.
